NEC MULTEOS M401, Руководство пользователя

Страница: 8 / 41

English-6
Attaching Mounting Accessories
The display is designed for use with the VESA mounting
system.
1. Attach Mounting Accessories
Be careful to avoid tipping monitor when attaching
accessories.
Mounting accessories can be attached with the monitor in
the face down position. To avoid damaging the screen face,
place the protective sheet on the table underneath the LCD.
The protective sheet was wrapped around the LCD in the
original packaging. Make sure there is nothing on the table
that can damage the monitor.
When using mounting accessories other than NEC
compliant and approved, they must comply with the VESA-
compatible mounting method.
2. Using optional table top stand
CAUTION: Installing and removing the stand must be done
by two or more people (M401/M461), by four or
more people (M521).
a. Installing and removing optional table top stand
To install, follow those instructions included with the stand or
mounting apparatus. Use only those devices recommended
by the manufacturer.
Handle with care when mounting LCD monitor stand and
avoid pinching your fingers.
NOTE: ST-M401461 is for M401, M461 and M521. (M521
may not be mentioned in ST-M401461 Installation
Instructions).
VESA Mounting Interface
300 mm (M401/M461)
400 mm (M521)
300 mm (M401/M461)
400 mm (M521)
NOTE: Before attaching the LCD monitor to the wall,
make sure that the wall can support the weight of
the monitor.
Be sure to remove the cord or chain from the wall
before moving the LCD.
3. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the
enclosure to allow heat to disperse, as shown below.
Allow adequate ventilation or provide air conditioning around
the monitor, so that heat can properly dissipate away from
the unit and mounting apparatus; especially when you use
monitors in multiple screen.
b. Prevent Tipping
When using the display with the optional table top stand,
fasten the LCD to a wall using a cord or chain that can
support the weight of the monitor in order to prevent the
monitor from falling. Fasten the cord or chain to the monitor
using the clamps and screws which are included with the
optional table top stand.
250mm (M401/M461)
400mm (M521)
Screw Holes
Cord or chain
Screw
Clamp