E1
MT1065/MT1060/MT860 User’s Manual Supplement
This document provides updated information that supplements the MT1065/MT1060/MT860 User’s Manual.
Read this supplement
as well as the User's Manual for each model.
1. Auto 3D Reform (not available on MT860)
Auto 3D Reform automatically corrects distortion by sensing the outline or outer frame of your screen with the projector’s built-in
image sensor to project an image within the screen.
NOTE:
• The Auto 3D Reform feature supports screen sizes between 30” and 200”.
• If the screen has the same brightness as its background, the built-in image sensor on the front of the projector can fail to recognize the outline or
outer frame of the screen.
Should this happen, the Auto 3D Reform feature cannot function.
If irregular colors, flaw or change of color are seen on the screen, the built-in sensor can mistakenly interpret the outline or outer frame of the
screen.
• If there is an object between the built-in sensor and the screen, the screen cannot be recognized.
• The Auto 3D Reform feature does not support reflective screens. Matt type or beads type screens are recommended.
Executing the Auto 3D Reform feature
1. Project an image.
See the user’s manual or the quick connect guide for projecting an image.
2. Press the 3D REFORM button.
The 3D Reform (Cornerstone) screen is displayed.
Projected area
3. Press and hold the AUTO ADJUST button for a minimum of 2 seconds.
A guide pattern that shows available area for Auto 3D Reform is displayed.
* The AUTO ADJ. button on the remote control can also be used for this
purpose.
4. Place the projector adjusting its orientation and the angle so that the out-
line (outer frame) of the screen can be positioned within the gray area of
the projected guide pattern.
Screen’s outer frame
