NEC MG-SIP, Руководство по настройке

Страница: 24 / 81

MG-SIP Page 24 of 75 5/8/2009
The following prompt appears, indicating that the Maintenance Console command entry is ready:
An example of indication is shown below:
The user input command above consists of several components. The following describes these
components using one of the
set commands.
Input the desired command, sub command and each required parameter after the prompt (“MG-SIP>” as
an example here) is indicated. Parameters vary depending on the specified command. When each data
(command name, sub command name, parameter) is specified correctly, the command executes the
required data processing, and then informs the processed result on the screen. When all the command
operation is completed, you may input “exit” after a prompt.
Note:
During the maintenance command program is activated, it also provides a help function
for referring to available command and sub command. After a prompt is indicated, request to
list up all the command help by “help” or “?” after the prompt and press the Enter key. If you
know more details about each command, it is also available to list up the target help by
“command name
Δ
?” after the prompt, and press the Enter key. The example below shows
the screen when executing help function regarding “? (help)” and “set address”.