49
5. Using On-Screen Menu
...
Expand
Language
Auto setup
Keystone
Security
Power management
Test pattern
Network setup
Control ID
Factory default
Lamp counter reset
Filter
Expand
Security
Off
PIN code lock
PIN code change
[Power management]
To reduce power consumption and maintain life cycle of light source, the power management function will turn off
the projection light source if your projector has no signals for a period of time.
1) Press
▲ ▼
button to select [Power management] menu.
2) Press <ENTER > button.
3) Press
▲ ▼
button to switch required item.
Ready......the power light indicator flashesgreen when the lamp is fully cooled down. The light source turns on
again if an input signal is connected or any key (except the power button ) on the side panel and remote controller
is pressed during this period of time.
Shut down......The projector shut down after the light source is fully cooled down.
Off......Disable the power management function.
Timer......Once the input signal is interrupted and no keys has been pressed for 30 seconds afterwards, the “No
signal” message displays in the timer. The timer counts down until the light source turns off. Press arrow key to set
up the timer in range of 1~30 minutes.
Ready countdown......Set the interval from ready mode change to standby mode (0 to 30 minutes) automatically.
When it is set it to zero, the projector will never change automatically. Press the Power key to change your projector
into standby mode and any other key to power on.
NOTE:
• Factory default for standby time: 5 minutes. Count down for ready mode: 5 minutes.
• When selecting [Off], the [Timer] and [Ready countdown] is unavailable.
• When selecting [Shut down], the [Timer] is unavailable.
...
Expand
Language
Auto setup
Keystone
Security
Power management
Test pattern
Network setup
Control ID
Factory default
Lamp counter reset
Filter
Expand
Power management
5 Min
5 Min
Ready
Off
Timer
Ready countdown
Shut down
Remaining time before
poweroff the light source.
0 1
:
2 0
No signal
