NEC LE2200, Руководство пользователя

Страница: 94 / 150

4-34
Upgrades and Options
9. Replace the side panel and front panel, and power on
the system.
10. Remove the drive serial number from the equipment
log.
3.5-Inch Diskette Drive
You may need to replace the 3.5-inch diskette drive
located in bay D. Contact your sales representative or
dealer for a list of approved devices.
R e m o v i n g t h e 3 . 5 - I n c h D i s k e t t e D r i v e
1. Power off the system and remove the side panel as
described earlier in this chapter.
Notice: Observe static precautions. Use an antistatic
wrist strap.
2. Disconnect the power cable and signal cable from
the rear of the diskette drive. Note the orientation
of the red (pin 1) cable.
3. Remove the screw that secures the diskette carrier
to the front bay (Figure 4-18).
4. Slide the diskette carrier back until the tabs hit
their stops. Pull the carrier away from the front bay
and remove it from the chassis.
5. Remove the screws that hold the diskette drive to
the carrier (Figure 4- 19).
6. Slide the diskette drive out of the carrier.
7. Proceed to the next section to install a replacement
diskette drive.