NEC Express5800/120Rc-2, Руководство по выпуску

Страница: 6 / 6

4 Express5800/120Rc-2 System Release Notes
Windows 2000
!
After installing Windows 2000, the Windows 2000 Device Manager may
show an NEC GEM SCSI Processor Device and/or an Unknown Device
under Other Devices. The Unknown Device is a reference to the baseboard
management controller. Installing the ESMPRO Agent can clear both of
these conditions.
SCO
The following advisory applies when using SCO 5.05.
!
During the installation of SCO or any time thereafter when booting SCO a
warning message may appear as follows:
WARNING: Cannot connect to APM, error 0x0036 System loaded, press
<Return> to start:
To prevent the WARNING message from appearing, boot the system to
single-user Mode. Edit the /etc/default/boot file. Add "apm.check=no" to the
end of the line indicated by the "DEFBOOTSTR=" entry.
System Hardware
The following advisory applies to the USB ports on your server's external device
connectors.
!
The factory standard default value of the USB ports on your server is
"Disabled". To enable them, the USB Controller feature in the Peripheral
Configuration Submenu of the BIOS Setup Utility described in Chapter 3
"BIOS Setup Configuration Settings" must be changed to "Enabled".
The following advisory applies to the Plug and Play feature of your server's I/O
expansion boards.
!
The factory standard default value (PnP O/S) of the Plug N Play feature in
your server is selected. The Windows 2000 operating system requires that
the PnP O/S feature be selected. To deselect it, if required by your operating
system, the Installed O/S feature in the Advanced Submenu of the BIOS
Setup Utility described in Chapter 3 "BIOS Setup Configuration Settings"
can be changed to "Other."
The following advisory applies to the SCSI interface cabling within your
system.
!
The external SCSI connector located on the rear panel of your server unit is
not connected internally unless an optional RAID controller is installed.