NEC ELECTRA ELITE IPK II, Руководство по аппаратному обеспечению системы, Страница: 535 / 642

Electra Elite IPK II Document Revision 3
System Hardware Manual 11 - 31
___________________________________________________________________________________
___________________________________________________________________________________
3.9 Wall Mounting
Any Electra Elite Multiline Terminal can be mounted on a wall. Multiline
Terminals can be wall mounted by using the base unit that comes with the
Multiline Terminal or by using the WMU-U Unit to accommodate adapters that
are installed on the Multiline Terminal.
The Wall Mount Unit is required when an APA-U, APR-U, CTA-U, CTU(S)-U
or HFU-U Unit is installed.
3.9.1 Removing and Remounting the Handset Hanger
1. Remove the hanger by sliding it out of the slot. Refer to Figure
11-38 Positioning the Handset Hanger .
2. Install it back in its original position so that the hanger
protrudes providing a rest for the handset. (This procedure
applies when using either the base unit or the WMU-U Unit.)
Refer to
Figure 11-38 Positioning the Handset Hanger for the
steps for removing and remounting the handset hanger.
3.9.2 Wall Mounting using the Base Unit
1. Refer to Section 2 Preparing Multiline Terminal for Adapter
Installation , and perform Steps 1~5.
2. Press both sides of the base cover and turn it left to remove it.
3. Rotate base cover 180°, and install it again on the Multiline
Terminal.
Figure 11-38 Positioning the Handset Hanger
A
B