NEC ELECTRA ELITE IPK II, Руководство по аппаратному обеспечению системы, Страница: 249 / 642

Electra Elite IPK II Document Revision 3
System Hardware Manual 6 - 107
___________________________________________________________________________________
___________________________________________________________________________________
2. Line up the four screws with the four slots in the drive mounting
bracket, then lower the drive into the bracket. Make sure all
four screws are seated in the bracket. Refer to
Figure 6-57 Line
up Four Screws .
3. Slide the drive toward the connector, making sure all the pins
line up with the connector. Push until it is firmly seated in the
connector. There should be no exposed pins. Refer to
Figure 6-58 Slide Drive Toward Connector .
4. Carefully tighten the four screws.
5. The ETU is now ready to be installed in the KSU.
Figure 6-57 Line up Four Screws
Figure 6-58 Slide Drive Toward Connector