NEC ELECTRA ELITE IPK II, Общее описание устройства

Страница: 99 / 174

Electra Elite IPK II Document Revision 1
General Description Manual 2 - 53
J
Direct Station Selection - one-button access to extensions
J
Station Speed Dial - one-button access to stored numbers (up to 24 digits long)
J
Speed Dial– System/Group/Station - one-button access to stored speed
dialing numbers
J
Trunk Calling - one-button access to trunks or trunk groups
J
Service Codes - one-button access to specific Service Codes
An extension user can chain dial with One-Touch Keys. For example, a user can
store the number for a company’s Automated Attendant in key 1 and employee
extension numbers in keys 2~5. The user presses key 1 to call the company, then
one of keys 2~5 to ring the employee to which they want to speak.
An extension user or system administrator can optionally store a Flash command
under a One-Touch key. This is helpful for One-Touch Keys used as Station Speed
Dial bins. The stored Flash may be helpful to access features of the connected Telco,
PBX or Centrex.
Operator
When an extension user dials “0”, calls are routed to a main system operator. The
operator can answer and route outside calls or locate employees using the Page
feature.
A maximum of eight operators are available.
OPX (Off-Premise Extension)
Off-Premise Extension allows a single line telephone, located remotely from the main
installation site, to access the system features with the same abilities as an on-
premise single line telephone.
Paging, External
With External Paging, a user can broadcast announcements over paging equipment
connected to external Paging zones. When a user pages on of these external zones,
the system broadcasts the announcement over the speakers. Like Internal Paging,
External Paging allows a user to locate another employee or make an announcement
without calling each extension individually.
The Electra Elite IPK II system allows up to eight External Paging zones, or a
common zone output provided by the KSU (Zone #9). All other zones (#1~8) requires
a port on a PGD(2)-U10 ADP, with a maximum of two external paging circuits per
module. You must have four PGD(2)-U10 ADP to get the eight external zones. In
addition, each external zone has an associated relay contact. When a user pages to
a zone, the corresponding contact activates (closes). This provides for Paging
amplifier control.