E-54
■
Lamp Unit Replacement
The target replacement time of the lamp used on this projector is 1400 hours. (This may be
shortened depending on the conditions of use.) Since there is a high possibility of lamp
explosion if the cumulative usage time exceeds more than 1500 hours, the power to the
lamp is cut off at 1500 hours.In the following instances where the cumulative usage time of
the lamp is more than 1400 hours, replace the lamp unit (sold separately). When the
projected image becomes dark or projected colors are unsatisfactory, the lamp has reached
the end of its life. In this case, replace the lamp unit.
●
When the message shown below is displayed while the lamp is on (This appears when
the cumulative usage time of the lamp is more than 1400 hours.)
●
When “Lamp usage time” on the menu display has reached 1400 hours, the LAMP/
COVER LED blinks red.
The lamp usage time is displayed in the “Setting 1” menu for confirmation. (For details,
see page E-45.)
●
When the LAMP/COVER LED is on red without the lamp lighting.
(When the cumulative usage time of the lamp is more than 1500 hours.)
WARNING
• Do not replace the lamp unit immediately after you have turned the projector off.
The lamp becomes very hot and may cause a burn injury. Turn off the lamp, disconnect the power cord from the
power outlet, and then wait at least one hour before replacing the lamp.
• Do not touch the lamp with your hands. This may result in reduced brightness or reduced lamp life.
• This projector contains many glass components (e.g. a lamp and mirrors). If these glass components break,
handle them with care to prevent personal injury from glass fragments. Contact your dealer or an NEC qualified
service presonnel for repair.
CAUTION
• This lamp unit is not compatible with the lamp unit for DT100. Specify the exclusive lamp unit DT02LP.
Procedure
1
Remove the lamp unit cover.
Loosen the lamp unit cover screws using a flathead
screwdriver.
ON/
STANDBY
LAMP/
COVER
TEMP
Lamp usage 1400 hours.
Replace the lamp.
