2 - 35
2.6.2
Self-diagnosis shipment setting
The shipment settings for self-diagnosis data area (region) are given below.
2.7
Default inspection
2.7.1
Default setting of switches
Confirm that the following switch is set as follows.
(1) Power switch: OFF
2.7.2
Default setting of OSM
Confirm that each OSM setting is as shown in OSM display (section 2.3.3) table (user mode/
factory mode).
If the setting class is an item for each timing, carry out for each adjustment timing.
*
Only CONTRAST will be set to MAX (100%) when RESET button is pressed in the normal
mode.
2.7.3
Checking the labels
Confirm that the "SERVICEMAN WARNING", "rating label", "manufacturing date stamp", "SE-
RIAL NO. label", etc., are attached to the specified position, and have been checked.
2.7.4
Packaging
(1) There must be no remarkable contamination, tearing or scratches, etc.
(2) The model name must be accurately displayed.
(3) The SERIAL NO. must be attached. (Must be the same No. as the set.)
(4) The package must be accurately sealed.
0x08C to 0x08F
0x0B6 to 0x0B9
0x0C0
0x0C1
0x0C2
0x0C3
0x0C4
0x0C5
0x0C6
0x00
0x00
0x00
0x00
0x00
0x00
0x00
0x00
0x00
Heater operating time
Operating time
High voltage error rate
High voltage suspension rate
Short circuit rate
High voltage data error rate
Deflection suspension rate
Heater error rate
ABL error
ADR
Shipment Setting (H)
LABEL NAME
Содержание DPro2070SB
