English-28
COLOR SYSTEM
VIDEO input only
The selected Color System depends on the video format of the input signal.
AUTO
NTSC
Automatically chooses Color System setting based on input signal.
PAL
SECAM
4.43 NTSC
PAL-60
INPUT RESOLUTION
VGA (RGB) input only
Selects one of the following pair of resolutions as the input signal priority:
1366 x 768 or 1280 x 768 or 1024 x 768 (vertical resolution 768)
ASPECT*
1
Select the aspect ratio of the screen image.
NOTE: When the ASPECT is ZOOM, the image will be changed to FULL image before TILE MATRIX, and then
start TILE MATRIX. After TILE MATRIX, the ASPECT will be returned to the previous ASPECT or set ASPECT
during TILE MATRIX.
If you change H POSITION and V POSITION settings with a reduced image, the image would not be changed.
If SCREEN SAVER is set, the ASPECT setting automatically changes to FULL from what you set. Once SCREEN
SAVER is off the ASPECT setting will go back to the setting that you originally set.
This function is not available when MOTION in SCREEN SAVER is active.
When the ASPECT is set to ZOOM while TILE MATRIX is set to active, after releasing TILE MATRIX or ZOOM
will be active.
POINT ZOOM function has limitations, please refer to POINT ZOOM (See page 49).
NORMAL
Shows the aspect ratio as it is sent from the source.
FULL
Fills the entire screen.
WIDE
Expands a 16:9 letterbox signal to fill the entire screen.
1:1
Shows the image in a 1 by 1 Pixel format.
ZOOM
Expands/reduces the image.
NOTE: The areas of the expanded image that are outside of the active screen area are not shown. The reduced
image may have some image degradation.
ZOOM
Maintains the aspect ratio while zooming.
HZOOM
Horizontal zoom value.
VZOOM
Vertical zoom value.
H POS
Horizontal position.
V POS
Vertical position.
ADVANCED
OVER SCAN*
2
HDMI1, HDMI2, HDMI3, DisplayPort,
VGA (YPbPr), VIDEO inputs only
Some video formats may require different scanning modes in order to best display the image.
AUTO
Image size is set automatically.
NOTE: This function is not available if input signal is VGA (YPbPr), VIDEO or MP.
ON
Image size is larger than what can be displayed. The image edge will appear cropped.
Approximately 95% of the image will be shown on the screen.
OFF
Image size stays within the display area. The whole image is displayed on the screen.
NOTE: When you use a computer with HDMI out, please set “OFF”.
NOISE REDUCTION
VIDEO input only
Adjusts the amount of noise reduction. Press + or - to adjust.
TELECINE*
2
HDMI1, HDMI2, HDMI3, DisplayPort,
VIDEO, VGA (YPbPr) inputs only
Automatically senses the sources frame rate for optimal picture quality.
ADAPTIVE
CONTRAST*
2,
*
3
HDMI1, HDMI2, HDMI3, DisplayPort,
VIDEO, VGA (YPbPr), MP inputs only
Sets the level of adjustment for dynamic contrast.
If HIGH is set, the image is displayed clearly but it makes brightness unstable due to the wide gap of contrast
variation.
RESET
Resets all “PICTURE” settings back to factory settings
except
for PICTURE MODE.
*1: Except for MP.
*2: This function is not available in HDMI/DisplayPort MODE when RGB is selected or when AUTO is selected and the input signal is RGB.
*3: This function is not available for still image by MP input.
