English−17
English
To connect the monitor to your system, follow these instructionsG
ROTEG:
before installation.
1. Turn off the power to your computer.
2. Place the monitor face down on a non-abrasive surface.
3. Connect devices to the monitor.
HDMI
Power cord
DisplayPort
D-SUB
Headphone
Audio IN
CAUTIORG
Use the provided specified cables with this product so as not to interfere with radio and television reception.
For mini D-Sub 15-pin, please use a shielded signal cable with core.
For HDMI and DisplayPort, please use a shielded signal cable.
Use of other cables and adapters may cause interference with radio and television reception.
CAUTIORG
• Do not connect headphones to the monitor while you are wearing them. Depending
on the volume level, it may damage your ears and cause loss of hearing.
ROTEG
• Adjustment of the volume control as well as the equalizer to other settings than the center position may increase
the ear-/headphones output voltage and therefore the sound pressure level.
•
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.
•
Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD
module and/or shorten the module’s life.
4. Connect the power cord to a power outlet.
ROTEG
• Please refer to the Caution section of this manual for proper selection of the AC power cord (see
).
•
Please make sure that enough power is supplied to the monitor. Please refer to
in the
“Chapter 4 Specifications” on page 26
5. Turn on the monitor by pressing the button and then turn on the computer.
ROTEG
If you have any problems please refer to the Troubleshooting section of this User’s Manual (see
