4
Quick Start
–continued
To attach the AccuSync
™
monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Plug the end of the video signal cable of the monitor in the video
signal connector of the computer.
(Figure A.1).
Tighten all screws.
For the Mac: Connect the Macintosh cable adapter (not included) to the
monitor connector on the Macintosh
(Figure B.1).
Attach the 15-pin mini
D-SUB end of the video signal cable to the Macintosh cable adapter on
the computer
(Figure B.1).
Tighten all screws.
NOTE: To obtain the AccuSync Macintosh cable adapter, call NEC-Mitsubishi
Electronics Display of America, Inc. at (800) 632-4662.
4. Connect one end of the power cord to the AccuSync monitor and the other
end to the power outlet
(Figure C.1).
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use
section of this manual for proper selection of power cord.
5. Turn on the monitor and the computer.
NOTE: If you have any problems, please refer to the
Troubleshooting
section of
this User’s Manual.
Figure A.1
15-pin mini D-SUB
Captive Signal Cable
AS500700700M900FINAL2.p65
10/24/03, 10:13 AM
4
