English-6
Quick Start
To attach the MultiSync LCD monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2.
For the PC or Mac with DVI digital output:
Connect the DVI-D to
DVI-D signal cable to the connector of the display card in your
system (
Figure A.1
). Tighten all screws.
For the PC with Analog output:
Connect the 15-pin mini D-SUB to
DVI-A signal cable to the connector of the display card in your system
(
Figure A.2
).
For the Mac:
Connect the MultiSync Macintosh cable adapter to the
computer (
Figure B.1
). Attach the 15-pin mini D-SUB signal cable to
the MultiSync Macintosh cable adapter (
Figure B.1
).
NOTE:
Some Macintosh systems do not require a Macintosh cable
adapter.
3. Remove connector cover. Connect the DVI signal cable to the
connector on the back of the monitor. Place the video signal cable
(
Figure C.1
).
Replace connector cover.
NOTE:
Incorrect cable connections may result in irregular operation,
damage display quality/components of LCD module and/or
shorten the module’s life.
4. Connect one end of the power cord to the AC inlet on the back of the
monitor and the other end to the power outlet (
Figure D.1
).
NOTE:
Please refer to Caution section of this manual for proper
selection of AC power cord.
5. Check the Vacation Switch on the right hand side of the monitor is in
the ON position. Turn on the monitor with the Power Button
(
Figure E.1
) and the computer.
NOTE:
There are two switches: one on the right side and one on the
front side of the monitor. DO NOT switch on/off quickly.
