1 - Using the Phillips head screwdriver, remove the two OE screws and set aside. You will want
to save these in case you ever want to remove the antenna mount.
2 - Carefully pull the light away from the cab. Disconnect the wiring harness and set aside.
3 - Remove BOTH metal screw tabs from the cab. Save these tabs with the OE screws.
4- Route the cables through the cab following the brake light harness as shown.
Seat the antenna mount pins on each side into the exisiting cab holes.
There is an
alignment pin
o assist in proper
1,
seating on each
side of the adapter
5 - Install the left side support bracket as shown sliding behind the cab - use two (2) of the
supplied hex screws and one (1) bracket as shown. LEAVE HAND TIGHT. Repeat this process
�
~
-
NOTE
THESE TWO BRACKETS SLIDE BEHIND THE CAB FRAME
-
YOU
WILL NEED TO SECURE THEM WITH THE SUPPLIED HEX SCREWS
.
**
Tighten BOTH sides down once you are sure the antenna mount is seated properly
.
**