NDS Dometic PSB12-40, Инструкция по установке и эксплуатации

Страница: 17 / 444

EN
Determining the cable cross-section
The cable cross-section of the power cables depends on the model and on the cable length.
Table 4: Cable cross-section
Model
I <
2 m 2 m
< l <
4 m
l >
4 m
Input Output Input Output Input Output
PSB12-40 16 mm² 16 mm² 25 mm² 25 mm² 35 mm² 35 mm²
PSB12-80 35 mm² 35 mm² 50 mm² 50 mm² 100 mm² 100 mm²
PSB24-40 16 mm² 16 mm² 25 mm² 25 mm² 35 mm² 35 mm²
PSB24-60 35 mm² 25 mm² 50 mm² 35 mm² 100 mm² 50 mm²
PSB12/24-20 25 mm² 16 mm² 35 mm² 16 mm² 100 mm² 25 mm²
PSB12/24-40 35 mm² 16 mm² 50 mm² 25 mm² 100 mm² 35 mm²
PSB24/12-40 16 mm² 16 mm² 25 mm² 25 mm² 35 mm² 35 mm²
PSB24/12-80 35 mm² 35 mm² 50 mm² 50 mm² 100 mm² 100 mm²
Select power cables of the suitable cross-section.
Connecting the charger
WARNING! Electrocution hazard
Observe the recommended cable crosssections, cable lengths and fuse.
CAUTION! Fire hazard
Place the fuses near the batteries to protect the charger from short circuits and possible burning.
NOTICE! Damage hazard
Do not reverse the polarity.
Observe the following instructions when connecting the charger:
• Select the appropriate connection variant, Connection variant A , Connection variant B , Connection variant C ,
Connection variant D , Connection variant E .
• Use suitable measuring instruments:
• Multimeter with DC voltage measurement, 200
V or autoscale
• Amperometric clamp with direct measurement (100 A scale or higher)
• Always connect the charger before connecting the batteries.
• Do not use ferrules. Strip the cable ends as follows:
• Signal cable 12
mm (0.5 mm² … 1.5 mm²)
• Charging cable 15 mm
fig.  on page 3
1. Connect the negative pole of the starting battery to
GND
.
15