NDS 90T2071, Руководство пользователя, Страница: 14 / 32

Note:
The transmitter and receiver are not limited to line-of-sight operation, i.e., the pair will operate
despite the presence of intervening obstacles. However, neither unit should be completely surrounded by
metallic objects.
Passing Video:
Before attempting bonding , connect a DVI or SDI video source to the Tx unit and a display to the Rx unit
via its DVI output (Figure 2). Once the bonding completed, t he indicator LED’s should turn blue and the
source image should appear on the display. This completes the basic setup.
Bonding the Transmitter (Tx) and Receiver (Rx)
Before the ZeroWire G2 wireless system can be put into service , the Tx and Rx pair must be
bonded. Connect an included power supply or a ‘Y’ Adapter cable to a Tx and an Rx unit. See pages 4
and 5 for ‘Y’ Adapter cable information and Power Connector location.
Once a Tx and Rx pair is bonded, they remain bonded until the Tx is explicitly bonded to another Rx or
the Rx is explicitly bonded to another Tx.
Note : If a bonded pair is turned off they will automatically
bond to each other when they are turned on again.
Bonding Procedure:
1. Press and hold the “bond” button (see Figure 1 for location) on the Tx unit for 5 seconds, then release.
Next press and hold the “bond” button (see Figure 1 for location) on the Rx unit until for 5 seconds ,
then release.
2. When the bonding process is complete each unit’s LED will be steady blue.
ZeroWire G2 Tx and Rx units are not compatible with earlier ZeroWire Tx and Rx units.
7
Figure 1
Tx
Bonding Button
Press here
Rx
Figure 2
Tx
Rx
Endoscope
Processor