Bottom bracket sensors for E-Bikes
NCTE
Page
11
of
12
Possible error cases
In case of an unexpected defect of the electronics, it outputs a constant value of approx. 2.5 V, the value
corresponds to a torque of 0 Nm.
If the sensor is blocked, please contact the manufacturer immediately and do not continue to use the
product.
Scope of delivery
The sensor system consists of a calibrated sensor, including a connection cable (corresponding to the
configuration) and a loose adapter. In case of the BSA 73 mm variant, an additional spacer is included in the
right bearing shell. The signal recording and processing is integrated in the housing.
Handling and transport
During handling, storage and transport make sure the sensor is not exposed to magnetic fields (e.g.
demagnetizing coils or permanent magnets). It must also be ensured that no magnetic tools are used during
mounting.
Important technical safety instructions
▪
Opening the sensor is not permitted.
▪
The sensor must not be subjected to any mechanical loads when not installed (drops, knocks,
vibrations, etc.).
▪
To prevent damage caused by a short circuit on the connecting cable, a suitable back-up fuse (approx.
1 A nominal current) must limit the current supply to the sensor.
▪
The sensor may only be operated within the permitted load limits. These can be found accordingly
in the standard DIN 15194:2018-11 and ISO 4210:2018. Cycles Safety requirements for bicycles part
2: Requirements for city bicycles chapter 4.13: Pedals and pedal/crank drive system
▪
Reverse polarity or overvoltage on the connecting leads can damage the sensor.
▪
Routing the wires outside the bike frame can cause interference with the sensor. NCTE recommends
routing the connection and data lines inside the frame. If internal routing is not possible for technical
reasons, the irradiance sensitivity must be re-evaluated accordingly by the EPAC manufacturer.
Disposal
Dispose of the article and all associated components via an authorized disposal company. Observe the
currently applicable regulations. If in doubt, contact your waste disposal facility to find out about
environmentally compatible disposal.
Service
Contact
Phone:
+49 89 66 56 19 0
E-Mail:
