NCR RealScan 7837-3000, Руководство пользователя

Страница: 141 / 183

Chapter 10: Serial Programming Commands 10-5
[ACK], MIN2[ACK],
MAX60[ACK],
DFT[ACK].
This response indicates that the device’s Coda ing Enable
(CBRENA) is set to 1, o
the Charac to 0, or D mit
the Check Character (C t to 0, or Not Required;
concatenatio (CCT) is abled;
the Minimum Message ) is set to ters;
the Maximum Message is set to
and the Default setting value.
Trigger Commands
Y and d e scanner with serial trigger
commands. First, the s t in Manual/Serial rigger
Mode either by scanni l/Serial Tr de bar code (see
C send Serial M mma d . Once
the ger mode, the trigge ated nd
deactivated by sending e following comman
A
D SYN U CR
The scanner scans unti r code has been re the
command is sent, or un serial time ‐ out h reach (see
Read Time ‐ Out (Serial Mode) in Chapt a description,
and the serial comman is chapter ).
Resetting the Standard Product Defaults
If you are not sure wha ramming options our nner, or
you have changed som ions and want the ettin s restored,
scan the Standard Pro ult Settings b below.
bar Cod
r on;
Start/Stop ter (SSX) is set on’t Trans ;
K2) is se
n set to 1, or En
Length (MIN 2 charac
Length (MAX) 60 characters;
(DFT) has no
ou can activate eactivate th
canner must be pu T
ng the Manua igger Mo
hapter 3), or by ing the Manual/ enu Co n
scanner is in serial trig r is activ a
th ds:
ctivate: SYN T CR
eactivate:
l a ba ad, until deactivate
til the as been ed
Trigger er 3 for
d in th
t prog are in y sca
e opt factory s g
duct Defa ar code
Standard Product Default Settings