NCR 7882, Инструкция по установке и эксплуатации

Страница: 22 / 58

7882 Scanner Installation and Owner Guide
04/01 497-0419630 Release D 22 of 58
Checkstand Cutout
1. Put the NCR 7882 into the hole in the checkstand. Diagrams in NCR 7882
Specifications show the various dimensions of the hole.
2.
Align the 7882 to the Checkstand. The leading edge of the Top Plate must be flush
or up to 1/16 in. (0.15 cm) below the top of the checkstand. The trailing edge of the
Top Plate must be flush or up to 1/16 in. (0.15 cm) above the top of the checkstand.
Correct Alignment
High Surface
Low Surface
High Surface
Low Surface
14231
Scanner Too Low
Bad Alignment
Bad Alignment
Scanner Too High
Checkpoint Cable
If you are installing and NCR 7882 Scanner, with the Checkpoint feature, on a Vertical
Mounting Bracket, route the Checkpoint Cable along side the Interface Cable.
Note – If the installation includes the Checkpoint feature, a representative from
Checkpoint must connect the Checkpoint Cable to the Checkpoint equipment after you
install the NCR 7882.
Cable Clamps
The NCR 7882 is supplied with two Cable Clamps (006-0687102). Install these clamps
under the checkstand as needed to support the cables and keep them out of the
operator’s way.