NCR 7197 II SERIES, Руководство пользователя

Страница: 111 / 308

7197 Series II Owner’s Guide Chapter 6: Commands
August 2011 86
m Feed and Cut Mode
0, 48 Full cut (no extra feed). Partial cut on the Sam.
1, 49 Partial cut (no extra feed).
65 Feeds paper to cutting po ( n times vertical motion unit),
and cuts the paper completely.
66 Feeds paper to cutting po ( n times vertical motion unit),
and performs a partial cut.
Range of m : 0, 48; 1, 49
65, 66 (when used with n )
Range of n : 0 - 255
Default of n : 0
Default of m : 0
Selects a mode for cutting paper and cuts the paper. There are two formats for this
command, one requiring one parameter
m , the other requiring two parameters, m and n .
The format is indicated by the parameter m.
Formulas: n times the vertical motion unit is used to determine the cutting position to the
distance that the paper is fed.

Example:

MSComm1.Output = Chr$(&H1D) & Chr$(&H56) & Chr$(m) & Chr$(n)
Exceptions:
If m is out of the specified range, the command is ignored.
Print Test Form
ASCII:
US t
Hexadecimal:
1F 74
Decimal:
31 116
Prints the current printer configuration settings on the receipt.
Disabled in page mode.

Example:

MSComm1.Output = Chr$(&H1F) & Chr$(&H74)
Exception: