Care of the Control Unit
Installing the battery
•
Remove the back panel of the enclosure and
insert the battery with the plus (+) and minus (-)
poles pointing in the designated direction
.
•
Use one 9 Volt (PP3) battery. A rechargeable
9V battery maybe used.
•
Remove the battery if the control unit will not be
used for a month or longer.
•
If the battery is incorrectly replaced, the control
unit will not function.
•
In the event of battery leakage, wipe the control
unit completely clean and install a new battery.
Cleaning
•
All surfaces of this system are non-porous and
should be cleaned between each client, using a
disinfectant wipe
Operating the control unit
What’s what?
Figure 1
Control Unit Front Panel
NB THERE IS NO AUDIO FEEDBACK
WHEN CLIENT IS IN THE TARGET RANGE
Page 3
1.
ON / OFF switch
2.
UPPER LIMIT
Dial to be used by therapist to establish upper
limit of target range
3.
OUTPUT for DataQ Unit
Socket for plug of red cable to transfer data
from control unit to DataQ Unit (
Figure 2)
See Accessories for DataQ
Figure 2
DataQ Output Socket
4.
Headphone Socket (Mono)
5.
Volume Control
For either speaker or headphone
NB Audio feedback by either speaker or headphone
6.
Low Battery LED
Battery needs to be
immediately
replaced or
recharged when LED comes “on”
7.
Speaker
8.
10 LED BAR DISPLAY
Real time visual feedback is provided by a 10
coloured LED display.
9. INPUT socket
For Angle Sensor plug
10
.
LOWER LIMIT
Dial to be used by therapist to establish lower
limit of target range
3
3
RED
LED
bars
represent
LOWER
values
7
GREEN
LED
bars
represent
HIGHER
values
4
5
7
8
6
9
10
1
2
DataQ
socket
