Command Descriptions:
The following commands can be setup through the ProCab user interface and sent by
the Mini Panel:
Accessory/Macro commands covered in this manual
Accessory Command - all NMRA standard accessory addresses (1-2044) can be
sent via the accessory command
Macro command - all NCE macro numbers (0-255) can be sent via the Macro
command
Link Command
Delay Command
For a complete description of the other commands shown in the
MENU NAVIGATION CHART on page 9 see the Mini Panel Technical
Reference.
Locomotive commands
- Speed and functions may be controlled
Select loco .
Speed commands
Function commands
Signal commands
Signal Command
Other commands
There are 6 groups of ‘other’ commands executed by the Mini Panel. These
commands do not result in a DCC command being sent but control the flow of the
commands from the Mini Panel.
Delays
Wait
Link
OPs Prog CV
Skip
Nop
Terminate
Disabling inputs
The sending of commands when certain inputs are grounded can be disabled
Continuous Memory
Command strings are normally limited to 4 commands per input (unless you LINK to
another command). This limitation can be removed for the writing of layout
automation "programs". Memory can be made continuous above a certain input
number so that up to a total of 124 commands can be strung together.
Warning: This product contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm.
Warranty
This product is fully factory tested and warranted against manufacturing defects for a period of 1 year. As the
circumstances under which this product is installed can not be controlled, failure due to installation problems can not
be warranted. This includes misuse, miswiring, operation under loads or voltages beyond the design range of the
product.
For warranty or non-warranty repair/replacement send the product (an any payment, if required) to:
NCE Warranty Center 82 East Main St. Webster, New York
14580
05240230
05240230
Last revised: 9 December 2008 Page 10
