NCD Explora 450 Series, Инструкция по установке, Страница: 33 / 62

Installing Additional Memory
Installing Optional Equipment in the Space-Saver Base 5-7
2. Insert the
SIMM
into the slot at about a 45-degree angle. (See
Figure 5-6.)
3. When you are certain the
SIMM
is inserted all the way, press down on both
ends of the
SIMM
until it clicks into place. The
SIMM
should go past the
metal tabs on each end of the slot.
The
SIMM
should lie at about a 25- to 30-degree angle in the slot.
Removing SIMMs
To remove a
SIMM
:
1. Use your two forefingers or your thumbs to pull back on the two metal
tabs located on each end of the
SIMM
slot. (See Figure 5-7.)
Figure 5-6 Inserting the SIMM
Metal tabs
Metal tab
Figure 5-7 Metal Tab Locations