NCD Explora 450 Series, Инструкция по установке, Страница: 30 / 62

Installing Additional Memory
5-4 Installing Optional Equipment in the Space-Saver Base
Disassembling the Space-Saver Base
To disassemble the space-saver base, follow these steps:
1. Remove all cables connected to the
NC
.
2. If you are using the stand, remove the
NC
from the stand.
3. Place the
NC
on a flat surface (preferably, on an anti-static mat) with the
top facing up, as shown in Figure 5-2. As you face the
NC
, the three
connectors are on your right.
4. Use a small flat-blade screwdriver to press on the tab located near the back
of the
NC
on the connector-side. At the same time, gently pull the
NC
’s top
section up.
5. Repeat step 4 for the tab on the opposite side of the base.
Figure 5-2 Pressing the Tabs