7)
PC setting
Set computer’s TPC/IP as
Obtain an IP address automatically, Obtain DNS server address automatically as
following picture showed.
the computer will abtain the IP address from router or base station.
8 ) Tr o u b l e S h o o t i n g :
F 1 The Failure phenomenon and solution
Failure phenomenon
Solution
SYS Indicator off
Pls make sure the PoE module connection is right. POE Port
connect with CPE, LAN port connect with computer
Can’t land to CPE through Web page
Pls check the IP address of computer and CPE to see whether they
are in same networking segment, The method is click “start”-“Run”
input“cmd”
，
ping 192.168.1.1 to test the CPE connectivity.
Reset CPE and load it again
；
Pls make sure the IP address 192.168.1.1 is not occupied by other
device in CPE’s networking;
Check computer and cable problem, recommend to use 10/100M
UTP unshielded cable;
Clean up Arp binding from “Start”-“Run” input“cmd” arp –d
Clean the IE Brower’s temporary files and Cache file
。
CPE can’t connect with AP
（
the status display unconnected
）
Try to scan the avaliable wireless networking again
；
Make sure the CPE’s wireless standard
（
11b/g/n, 5.8G
）
is correct
；
The Security and passwords are matched between CPE and AP
；
The signal strength of AP is too weak to connect, should be more
than -75dBm
；
Can’t scan the wireless AP
Scan it several times more
；
Make sure there are 5G signal existed.
Reset the CPE, scan it again after CPE restart
；
The connection of CPE and AP is
success, but the computer can’t share
Pls Check the computer’s IP address and DNS setting. If it is
dynamin, set the network card as automatically obtain. If it is static
