NC-17 iPhone Bike Mount, Руководство пользователя

Страница: 51 / 66

49
completely and pull the quick-release (4) from
the clamp.
The clamp has two functions: 1. the clamping
on the handlebar (A), 2. the positioning of the
iPhone on the bike (B). Now open the clamp
and put it around the handlebar. Take the
quick-release (4) and insert it into the clamp
(3). Fasten the nut (5) by hand, with open
quick- release. Now place the Dogbone (7) in
the desired position and close the clamp above
the eccentric cam quick-release (F12). If the
applied clamping force is not suf
fi cient for the
safe adjustment of the holder, open the quick-
release lever again and
fi rmly turn the nut (5)
further in the clockwise direction. Repeat the
procedure until the desired adjustment of the
holder is reached.
Note: The nut (5) must be fastened only by
hand, don’t use any tools like pliers, since an
over-tightened nut destroys the holder. Make
sure that a gap remains between the upper and
the lower clamp (16). Use a thicker protective
tape (8) to create the gap if needed. Always
keep an eye on the desired position of the
iPhone. The quick release (4) enables you to
remove and install the holder as you like. If you
prefer a permanent assembly, replace the quick
release (4) by hex-key screw (10), also part of