Care and Cleaning
FCC Statement
Troubleshooting
14
□
Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully.
□
To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or
slightly dampened, clean cloth to wipe the exterior surface of the fixture.
Design Solutions International Inc.
Model:
XXXXXX
Address: 5101 NW 21st Ave, Suite 520, Fort Lauderdale, FL 33309
Telephone: 800-388-6141
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
CAUTION:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
Contains FCC ID:
2ANDL-WR3
Wi-Fi: 2.4GHz IEEE802.11b/g/n
Problem
Possible Cause
Solution
The LED lights will not light.
The LED is burned out.
Discontinue the use of the Smart LED Strip.
The power is off.
Ensure the power supply is turned on.
The power cord is not plugged in.
Ensure the power cord is plugged into the outlet.
The connector has faulty connections. Check the connectors connections.
The circuit breaker is turned off.
Ensure the circuit breaker is in the “ON” position.
The fuse blows or the circuit breaker
trips when the light is turned on.
There are crossed wires or the power
wire is grounding out.
Discontinue use of the Smart LED Strip.
Unplug the unit from the wall.
Check the wire connections. Contact a qualified electrician
or call the Customer Care Service Team at 1-800-388-
6141 ext. 216. For customer service support and the
fastest response, please email us at CustomerSupport@
DSILighting.com.
