Installation (continued)
8
□
There are 2 methods for installing your LED tape light:
• 4A Tape method: Working from one end to the other, remove the 3M paper backing and press into place. Press between the
LEDs to help ensure secure contact with the mounting surface. Avoid pressing on the individual LEDs as this could damage the
LED solder connections.
• 4B Clip and screw method: Place the LED tape light in the desired position. Use the clips and screws to secure the LED tape
light as shown. Clips should be placed in open areas of the strip. Do not cover the LED tape lights.
4
Installing the LED tape light
4A
4B
+
w
c
c
w
+
w
c
c
w
+
w
c
c
w
NOTE:
a. Use an angle greater or equal to 90 degrees when there is an LED chip on the corner while placing the strip in a concave
position. (Angle 90º)
b. Use an angle greater or equal to 60 degrees when there is no LED chip on the corner while placing the strip in a concave
position. (Angle 60º)
c. Use an angle greater or equal to 60 degrees when there is an LED chip on the corner while placing the strip in a convex
position. (Angle 60º) In the convex position the angle should not reach 90 degrees. See above diagram.
a.
b.
c.
LED Chip
Angle 90º
Correct
lncorrect
lncorrect
Angle 60º
