Installation (continued)
7
□
Unfold the entire LED tape light. Find the end of the LED tape light. Each group of twelve LED chips from the end is considered a
complete circuit as shown (each complete circuit has an IC). You can cut the LED tape light at the center of the 12th and 13th LED
chip as shown, along the scissors marks. If you cut the strip on the incorrect point, the remaining LED chips on the complete circuit
will not work.
3
Adjusting the length of the strip with scissors
End of the LED tape light
Cut line
□
Remove the protective tape from the adhesive back of the LED tape light (B) carefully. Attach the snap-on end cap (DD) to the new
end. Press the snap-on end cap (DD) tightly.
12
1
3
5
7
9
11
13
2
4
6
8
10
IC
WARNING:
Once the strip is cut, it cannot be reattached.
WARNING:
If you cut the LED tape light, you must use the snap-on end cap on the new end. If you do not use the provided
endcap, the strip can only be used indoors, not outdoors.
DD
B
