NBE RTB Tokyo, Руководство пользователя

Страница: 23 / 24

TROUBLESHOOTING:ALARMS
ERROR CODE ERROR NAME ERROR DEXCRIPTION
E1
ERROR LIGHT
SENSOR No light value (LUX) is recognized after an ignition
cycle. Check that the igniter functions in Manual
Control. Check that the burner grate is clean prior to
starting the grill. An unclean burner grate with
blocked holes can prevent the photosensor from
recognizing a completed ignition. If the problem
persists replace the photosensor.
E2
ERROR NO FIRE/
CHECK PELLETS No significant temperature increase (i.e. above 10
°C) over the hopper temperature baseline is
recognized within the last 5 minutes of operation.
Check the hopper for pellets and refill if necessary.
E3 ERROR HOT HOPPER The hopper temperature sensor is recognizing a
temperature above the maximum allowable hopper
temperature. Ensure that the heat is not escaping
from the hopper. If so, check for the influence of
wind direction and speed on the escaping of heat
through the hopper. If the wind speed and direction
is overly strong or erratic, refrain from using the grill
until the weather calms.
E4 ERROR BBQ TEMP
SENSOR One or more of the BBQ temperature sensor/s is out
of range (i.e. values less than -90 or higher than 900)
and is possibly damaged. Check the connection to
the print board and for any damage to the wires
themselves. Replace BBQ temperature sensor/s if
problem persists.
E5
ERROR HOPPER
TEMP SENSOR The safety temperature sensor for the hopper is out
of range and is possibly damaged. Check the
connection to the print board and the wires
themselves for any damage. Replace if necessary.
E6
ERROR AUGER
MOTOR OUTPUT Unwanted power consumption on the motor auger
output is detected. Possible damage on the motor
output. Replace print board if the problem persists.
E7
ERROR IGNITER Current consumption for the igniter is less than
300mA during the end of the ignition period.
Simultaneously no light (LUX) value is registered on
the photosensor. This may indicate that the igniter is
damaged. Check the functioning of the igniter in
manual control. Replace if necessary.
E8
ERROR KEYBOARD A keyboard error is detected. One or more of the
keyboard buttons are detected as being constantly
pressed. Try to massage the button to release it
from a pressed position. If the problem persists,
replace the keyboard folio.
23