Naxa NTD-4050, Инструкция по эксплуатации

Страница: 2 / 18

FCC Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Support
If you have problems with your device, please consult the instructions in this manual.
Please also visit us on the web at www.naxa.com to get up to the minute news,
alerts, and documentation for your device. For additional assistance, please
contact Naxa Technical support.
NAXA Technical Support
2320 East 49th St.
Vernon, CA 90058
Tel: (323 )-583-8883
http://www.naxa.com/naxa_support/
Made in China
9
Safety Information
Warning
To prevent fire and/or electric shock, do not use this plug with an extension
cord, receptacle or other outlet unless the blades can be fully inserted to
prevent blade exposure. Do not expose this appliance to rain or moisture.
CAUTION!
b\
RISK OF ELECTRIC SHOCK
�
�
DO NOT OPEN �
**''J
�ii
RISQUE DE CHOC ELEC TRIOUE/NE PAS OUVRIR
Important Safety Instructions
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
Please, unplug the TV power cord when the following conditions occur:
-When there is a thunderstorm (Please, unplug the power cord and antenna).
-When cleaning the TV set.
-When the TV set is not used for a long time.
Do not use corrosive solvents when cleaning the TV set.
Do not put the TV set in direct sunlight or near heat.
Do not put a heat source, such as a candle or heater, on top of or near the TV set.
Leave plenty of space (at least 10cm) around the TV set for ventilation.
Place the TV set away from where it can become wet (such as near a window).
Do not put a container with liquid (such as a vase) on top of the TV set.
Do not move the TV set when the power is on.
Do not touch, push, or scratch the surface of the TV set with hard materials or
items. When TV surfaces are dirty, please use a wet cotton cloth or soft cloth with
non-corrosive cleaners to clean it carefully. Do not use acetone, toluene or alcohol
to clean the TV set. Avoid excess moisture, which can damage inner electronic
components. If too much moisture is present, the TV screen may appear blurry or
spotty. It is recommended that a technician install the TV set on a wall, if such
placement is desired.
An incorrect wall installation will be unsafe and hazardous.
Do not let children climb on or play around the TV set to avoid falls, collisions,
damage, and/or injuries.
Do not hit the TV panel with hard objects.
Do not cover the TV set with blankets or other objects when it is connected to a
power source, which may cause overheating and fire.
Batteries shall not be exposed to excessive heat such as direct sunlight, fire or the
like. The power plug is used to disconnect the device. The disconnected device will
not operate while unplugged.
Apparatus with class I construction shall be connected to a electrical outlet with a
protective grounding connection.