LISTENING TO THE RADIO
OPERATING INSTRUCTIONS
1
NORMAL PLAYBACK
PLAYING MP3/CD
DISCS
1
7
5
After the last track has been played,
the disc stops automatically and the
display shows the total number of
tracks on the disc. If you are finished
listening, press the CD Door Open
Button
to open the CD Door.
Remove you disc and slide the
FUNCTION Switch to the
TAPE(OFF) position.
Set the VOLUME Control to a low
setting.
Slide the FUNCTION Switch to
the RADIO position.
Slide the BAND Switch to a
desired setting - AM, FM, or FM
STEREO
NOTE: If you select either the
FM or FM Stereo bands, be sure
to raise the FM rod antenna and
extend it to its full length.
When you have finished listening,
slide the FUNCTION switch to
the TAPE (off) position to shut
the power off.
Rotate the TUNING Control to
find the desired station.
NOTE: if the BAND Switch is set
to the FM STEREO position and
you have tuned to an FM stereo
station, the FM STEREO Led
Indicator will light.
Hints for Better reception
FM/FM Stereo - Make sure that the telescopic FM Rod Antenna is raised and extended to its full length. You may
have to vary the direction of the antenna to find the strongest signal for each FM station. If you are listening
to weak or distant FM Stereo station, the reception is unsatisfactory.
AM - The AM ferrite bar antenna is located inside the cabinet. It may be necessary to turn the unit slightly
so that the internal antenna is point in the direction of the AM transmitter. You may have to experiment
to find the position that provides the strongest reception for each of your favorite AM stations.
Set the VOLUME Control to a low
setting.
Slide the FUNCTION Switch to
the MP3/CD position.
Press the CD Door OPEN Button
to open the CD compartment door.
NOTE: If you have not already
done so, remove the CD transit
lock card from the CD compartment
now and discard it.
Begin automatically playback on
track 01. The desired track
can be played by remote control.
The MP3/CD player will read
the table of contents on the disc
and the total number of tracks
on the disc will appear on the
MP3/CD Track Display.
Place a MP3/CD on the center
spindle, with the printed label side
facing up. Close the CD
compartment door.
Adjust the VOLUME Playback
will continue until all the tracks
on the disc have been played.
To stop playback before the disc
ends, press the CD STOP ( )
Button. The disc will stop and
the display will show the total
number of tracks on the disc.
2
3
2
3
6
4
5
4
8
9
1
2
-5-
-4-