Naxa NPB-270, Инструкция по эксплуатации

Страница: 13 / 22

www.naxa.com Page 13
Using the AUX Input
Set the FUNCTION switch [14] to the CD, FM, or BT posi-
tion to play devices connected to the AUX Input jack [17].
⚠ L
The unit will switch to AUX mode automati-
cally when a player is connected to its AUX
input jack [17].
1. Connect the audio source to the player. Use an op-
tional audio patch cable (not included) to connect
the 3.5mm headphone or line-out jack of the audio
source to the 3.5mm AUX Input jack [17] found on
the rear of the player.
2. Prepare the player. Set the FUNCTION switch [14]
to any position other than “OFF”. Turn the VOLUME
dial [15] to lower the volume level.
3. Prepare the audio source. Start playback on the
device. Set the volume level of the device to ap-
proximately 80% of its maximum.
4. Adjust the final volume. Turn the VOLUME dial [15]
of the player to set the volume to a comfortable
level.
⚠ L
Use the audio source to control playback
(e.g., stop, play, next). Use the player to
control the volume.
Remember to disconnect the audio patch
cable from the AUX input jack [17] after use
in order to be able to listen to the radio or
CD player again.