Naxa NAS-3049, Инструкция по эксплуатации

Страница: 8 / 16

Page 8 Naxa Electronics
Using the USB/SD
Card Player
Your speaker can play MP3 files from USB memory
sticks or SD memory cards. Connect USB memory
sticks to the USB port [3]; load SD memory cards in the
SD card slot [2]. Turn the speaker on, then press MODE
to set the speaker mode to USB or SD.
When the speaker is in USB or SD mode:
To do this... ...do this
Start, pause, or resume audio
playback Press PLAY/PAUSE.
Skip to the previous track Press PREV/VOL–
Skip to the next track Press NEXT/VOL+
Decrease the volume level Press and hold PREV/VOL–
Increase the volume level Press and hold NEXT/VOL+
Switch the audio source mode Press MODE.
⚠
⚠
Do not remove USB sticks or SD memory
cards while the speaker is on. Doing so may
damage the speaker system or memory
card/USB stick.
FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY RESULT IN DAMAGE TO THE SPEAKER
SYSTEM AND VOID THE WARRANTY.
Using the AUX Input
Connector
Connect devices without Bluetooth
®
by using the AUX
connection. A 3.5mm stereo patch cable is required to
make this connection.
1. Use the included AUX cable to connect the device’s
headphone or line-out jack to the LINE IN (AUX)
connector (10) found on the back of the speaker.
2. Turn on the device and the speaker. Lower the vol-
ume on both.
3. Press MODE [7] to set the active source of the
speaker to AUX.