27
TROUBLESHOOTING
Problem
Possible cause
Solution
Difficulties in starting a cold
engine.
Low fuel.
Check the fuel level and add fuel if necessary.
Spark plug flooded or damaged.
Check, clean or replace the spark plug.
No spark on the spark plug.
Replace the spark plug with a new one.
No suction attached.
See the chapter: Starting the engine.
Contaminated air filter
Clean or replace the filter.
The equipment goes out and it
is difficult to restart.
The fuel mix has run out.
Fill the fuel tank.
Carburettor clogged.
Clean the carburettor.
Ignition switch off.
Turn off the switch.
Too much carbon deposits have
accumulated on the spark plug.
Clean carbon deposit collected on the spark plug.
Clogged / dirty fuel filter.
Replace it.
Choke enabled.
Turn off choke.
Low engine acceleration speed
and poor cutting power.
Clogged cylinder cooler, too much soot
has accumulated in the top of the cylinder.
Clean the cylinder.
Oil circulation blocked and / or air filter
blocked.
Clean
Weak or tight chain.
Adjust and / or sharpen.
Dirty air filter.
Clean or replace
Idle speed is not stable.
The fuel pin is too tight and / or the stop
screw is incorrectly adjusted.
Have it adjusted at the garden tools service. An
authorized NAX service is recommended.
The fuel pin is too tight and / or the oil is
too thick.
Have it adjusted at the garden tools service. An
authorized NAX service is recommended.
Water or dirt in the fuel system.
Change the fuel, and if it does not help - have it
repaired by qualified service.
CAUTION! If the device requires further maintenance, please contact the NAX Central Service.
DEVICE ASSEMBLY DIAGRAMS
Assembly diagrams of the device are on pages 9 and 10.
WARRANTY AND SERVICE
The product purchased by you is intended for amateur (hobby) use only. If the equipment is used for other purposes (commercial,
professional), it will lose the guarantor's liability for the purchased equipment. You can find information on the warranty and the NAX
service network in the attached warranty card.
Remember that the machine should be cleaned after each use. Keeping the equipment clean will ensure long-term and reliable
operation. Cleaning, maintenance and periodic inspections are not repairs. Authorized NAC services may perform these activities as
part of a paid service.
Содержание 500C
