5
NavTool.com | Call: +1-877-628-8665 | Text: +1-646-933-2100
Installation Instructions
Step 1:
Locate the back of the Vehicle’s Navigation System located either in the trunk or under the front seat
of the vehicle. (Vehicle disassembly may or may not be required depending on the vehicle)
Step 2:
Disconnect the 6 Pin Connector from the back of the Vehicle’s Navigation System.
Step 3:
Connect the female end of the Supplied Vehicle Specific Harness VA6P into the Factory Harness you
disconnected.
Step 4:
Connect the male end of the Supplied Vehicle Specific Harness VA6 into the back of the Vehicle’s
Navigation System. (where you disconnected the factory plug).
Step 5:
Connect both 10 pin connectors on the Interface harness and the Vehicle Specific Harness VA6P
together.
Step 6:
Cut off the Red (+12 Volts ACC) and Black (Ground) wires off of the 6-pin plug on the interface
harness.
Step 7:
Connect the Red wire (+12 Volts ACC) to the Vehicle’s factory accessory wire.
Step 8:
Connect the Black wire (Ground) to the Vehicle’s factory ground.
Step 9:
Connect the Orange wire (+12 Volt Reverse Input) to the Vehicle’s factory reverse wire.
Step 10:
Connect one wire of the push button to +12 Volt ACC power in the vehicle and the other wire to the
white manual activation wire on the interface harness. (Not required for installations with reverse camera only)
Step 11:
Connect your aftermarket cameras/video inputs to Rear Camera Input/Video Input 1 and Front
Camera Input/Video Input 2 on the interface harness.
Step 12:
Make sure both dip switches on the interface are facing UP in the OFF Position. Plug the interface
harness into the interface.
