Q6.COMP Is TZtouch3 compatible with Nobeltec TZ software?
TZ Professional and TZ Navigator can be connected to a TZtouch3 network.
Also, with a TZT16F or TZT19F you can utilize the HDMI IN port along with the USB
passthrough port to view and control a PC running TZ software.
Please contact
Nobeltec (TimeZero)
for additional information concerning compatible TZ
software versions.
Q7.COMP Can NavNet TZtouch3 be connected to a Fusion radio?
Yes. TZtouch3 can be connected to a Fusion Radio via an Ethernet connection. NMEA2000
connectivity is not available. The following Fusion models via “Fusion Link” are compatible;
MS700/750/755, MS-RA770, and MS-SRX400. Click here for
Fusion radio Link Guide
.
Q8.COMP Is TZtouch3 compatible with CZone Digital Switching Systems?
Yes. CZone functionality is available with TZtouch3. Please see the “Guides” section of any
TZtouch3 MFD product page for more information. Click here for
CZone Guide
.
Q9.COMP Which Remote Controllers are compatible with TZtouch3 Networks?
The MCU002, MCU004 USB Remote controllers, and MCU005 Ethernet controller are compatible
with both TZtouch2 and TZtouch3 MFDs. More than one MCU002/4/5 can be connected to a
single TZtouch3 or in a system. Once connected to a TZtouch2 or TZtouch3 MFD any MCU004/5
can control any TZtouch MFD in the system. MCU002 remote controllers only control the
TZtouch3 that they are physically connected to. Click here for
Remote Control Unit Guide
.
Q10.COMP Can additional USB devices be connected using a generic USB Hub?
Yes. TZtouch3 has a powered 5V USB port that can supply up to 0.5 Amps to any generic USB
Hub. This will allow you to connect additional USB devices, such as the SDU001 Chart Card
Reader, MCU002, MCU004 USB Remotes, USB Memory Stick, Mouse, keyboard, etc.
Q11.COMP Are standard Microsoft USB Mice, Pointing Devices, and Keyboards
compatible with TZtouch3 MFDs?
Yes, TZtouch3 is compatible with standard Microsoft USB mice or pointing devices, and
keyboards as long as a special driver in not required. You cannot load any drivers into a
TZtouch3 MFD. You can perform almost every function using a mouse trackball and wheel. The
only function that is not supported is pan and tilt while the plotter is in 3D mode which is only
supported by the two-finger touch operation.
4. NavNet DRS Radars
Q1.DRS
Will my NN3D DRS radar work with a TZtouch3 MFD?
Yes. Original, NN3D DRS radars are compatible with TZtouch3 MFDs if the DRS software is
version 1.16 or higher. A DRS power supply will need to be added to power the radar if it is
currently powered by the NN3D MFD. The following NN3D DRS power supplies are available.
PSU017 for use with a DRS4D
PSU012 for use with a DRS4A, 6A, and 12A.
PSU013 for use with a DRS25A (was included with the DRS25A)
