17
FISH450 Tricolor FISHFINDER
Installation and Operation Manual
NAVMAN
The
Key Beep
function is located on the
Setup
menu.
It allows the user to activate an audible beep each
time a key is pressed.
Pressing the
Cursor Right
key when the word
Key
Beep
is highlighted switches between
On
and
Off
.
4-9 Resetting to factory defaults
4-7 Key Beep
GENERAL
Auto Gain ................................ON
Auto Range ..............................ON
Manual Gain ...............................5
Bottom Lock ..........................OFF
Key Beep ...............................OFF
UNITS
Temperature .............................°C
Depth ..................................Metres
Speed ....................................KTS
Fuel ......................................Litres
ALARMS
Shallow Alarm .......................OFF
Shallow Alarm Value ............3.0 m
Deep Alarm ...........................OFF
Deep Alarm Value .............20.0 m
Fish Alarm .............................OFF
Fuel Alarm .............................OFF
Fuel Alarm Value ..............20 litres
Temp. Change Alarm ............OFF
Temp. Change Alm Val. ......2.0 °C
Temp. Alarm .......................OFF
Temp. Alarm Value ........25.5 °C
Low Battery Alarm ...............ON
Battery Alarm Value ...11.5 Volts
DISPLAY
Fish Symbol ...................
Speed Display .....................ON
Temperature Display ..........OFF
Display Cal ..............................9
Red Cal ...................................3
Blue Cal ...................................3
Backlight ..................................6
FUEL
Tank Size ......................70 litres
Num Engines ...........................0
Flow Filter .....................10 secs
OTHER
Keel Offset .......................0.0 m
Logs ............................ Trip Log
Language ..................ENGLISH
All settings may be reset to the
manufacturer’s defaults
settings. (See right.)
IMPORTANT: Resetting to
factory defaults will erase all
settings you have made except
fuel used (
Used
) and fuel
remaining (
Remaining
).
To enter the
Default Set
screen, first power off.
Hold the
Cursor Left
key down
and power on while continuing
to hold it down.
The message “RESET TO
FACTORY DEFAULTS?” will
appear.
Use the
Cursor Left
and
Right
key to switch between
Yes
and
No
, then press the
Menu
key
to continue the power on
sequence.
An internal simulator allows users to familiarise
themselves with operating the FISH450 Tricolor
off the water. When in
Simulate
mode the word
“
Simulate
” flashes on the bottom of the screen.
When in
Simulate
the unit generates data so that
all the main screens appear operational. Any
changes made to the backlighting, alarms and
display setup are saved, but the fuel log (
Used
)
and fuel remaining (
Remaining
)
are not affected.
To turn the
Simulate
mode on, power the unit off,
disconnect the blue transducer plug at the rear of
unit, then power the unit on.
To turn the
Simulate
mode off, power the unit off;
reconnect the blue transducer plug at the rear of
unit, then power the unit on.
4-10 Simulate
4-8 Language
Access the
Language
screen through the
Setup
menu.
To select a language, press
the
Cursor Up
or
Down
key
to highlight it, then press
the
Menu
key to save and
exit.
