Version 16.03.2023
HW: CAM(V100)/UP(V30) right
RL4-PCM60
P
a
g
e
7
1.4.1.
Activating the front camera (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear, depending on the menu
adjustments. In addition, a manual switch-over to the front camera input is possible via
keypad (short press) from any image mode.
Note: Description of the power supply output: see chapter “Power supply output for front cam”.
1.4.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed by switching through the interface’s video
sources. It is recommended to enable only the required inputs. So the disabled inputs will be
skipped while switching through the video interfaces inputs.
1.4.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.4.
Activating the guide lines (dip6)
If set to ON, the guide-lines will be shown on the display.
If set to OFF, the guide lines won’t be visible on the display.
1.4.5.
Monitor selection (Dip 7)
Dip 7 customizes the monitor-specific video settings which sometimes even vary within head
units of the same version, caused by different monitor specifications. If one dip position
doesn’t give a satisfying picture, try the other setting while a working video source is
connected to the chosen input of the interface. If there is no change of picture visible after
having changed the setting, retry and disconnect the 6pin plug at the interface box between
every change of the dip setting.
