Version 17.02.2022
HW: CAM(V100)/(V20) and CAM(V100)/(V20)GD
RL4-LR16-8/10
P
a
g
e
17
2.6.1.
Audio-insertion
This interface is only able to insert video signals into the factory infotainment. If an AV-
source is connected, the audio insertion has to be done by the factory audio AUX input or an
FM-modulator. The inserted video-signal can be activated simultaneously to each audio-
mode of the factory infotainment. If 2 AV sources shall be connected to the infotainment,
additional electronic is necessary to switch the audio signals.
2.6.2.
After-market front camera
The connection of an after-market front camera depends on the factory infotainment
system. In contrast to the Incontrol Touch infotainment with 8inch monitor, the enclosed
cable set for the connection of the Incontrol Touch Pro infotainment with 10.2 inch monitor
is equipped with an external relay.
2.6.2.1.
Connection - RL4-LR16-8 - Incontrol Touch with 8inch monitor
The red power supply output
ACC/front cam out 12V (max 3A)
can be used to power a front
camera. If Dip 1 is set to ON (of the black 8 dips), the power supply output su12V
(max 3A) when the reverse gear is engaged and additionally
10 seconds delay after the reverse gear is disengaged.
Note: In addition, a manual switch-over to the front camera input is possible via keypad
(short press) from any image mode. The power supply output su12V then, too (if Dip
1 is set to ON and the front camera input is selected).
