Version 22.02.2018
HW:
GD(V97)/(V33)
RL3-MIB-4
P
a
g
e
6
1.4.1.1.
Enabling the optical PDC function (dip 1)
If set to ON the interface will display an image of a car on the right side of the factory
monitor.
1.4.1.2.
Enabling the interface’s video inputs (dip 2-3)
Only by dip switches enabled video inputs can be accessed by switching through the
interface’s video sources. It is recommended to enable only the required inputs. Disabled
inputs will be skipped while switching through the video interfaces inputs.
1.4.1.3.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera or factory optical park system picture.
If set to ON, the interface switches to its rear-view camera input while the reverse gear is
engaged.
1.4.1.4.
Monitor selection (Dip 6-8)
Dips 6-8 customize the monitor-specific video settings which sometimes even vary within
head units of the same version, caused by different monitor specifications. It is necessary to
try all possible combinations while a working video source is connected to the chosen input
of the interface. One of the six combinations will show the best picture size and quality
(some may give no picture). It is possible to first hot plug through the dip combinations. If
there is no change of picture visible after trying all 6 options, retry and disconnect the 10pin
plug of the Quadlock connector between every change of the dip setting.
Note:
Dip 4 is out of function and has to be set to
OFF
!
Empirical value:
Vehicle
Monitor Dip 4
Dip 6
Dip 7
Dip 8
VW Golf7
8“
OFF
OFF
OFF
OFF
5.8“
OFF
OFF
OFF
ON
Audi A3 (8V)
7“
OFF
OFF
ON
OFF
5.8“
OFF
OFF
ON
ON
Audi A4 (8W), A5 (8T)
8.3“
OFF
ON
OFF
OFF
7“
OFF
OFF
OFF
OFF
Audi A6/A7 (4G)
8“
OFF
OFF
ON
ON
Audi Q7 (4M) Touch
8.3“
OFF
ON
ON
OFF
Audi Q7 (4M) MMI
7“
OFF
OFF
OFF
OFF
Porsche
OFF
OFF
OFF
OFF
VW Touran
OFF
OFF
OFF
OFF
