Version 28.04.2022
HW: CAM(V31)/(V10)
RL1-MIB2-E
P
a
g
e
19
Carefully lead the monitor’s brown colored 50pin ribbon cable into the preassembled ribbon
cable merger of the daughter PCB’s 50pin ribbon cable
“PNL
-
OUT”
.
Make sure that the
connector pins are faced to the
merger’s
platinum.
After a check of its perfect
position, close the ribbon cable merger’s lock, by folding back the
black hinge, to fix the connection again.
Fittingly, fold in the previously connected 50pin ribbon cable below the daughter PCB for
installing the PCB, facing with its rear-side to the monitor panel.
After leading through the 50pin ribbon cable
„CAR
-
IN“
and the picture signal cable, install
the daughter PCB in the inner recess of the metal frame and fix the frame by using the 4
screws.
