Version 26.01.2022
HW: CAM(100)/(V20/Y+V41)
CI-RL4-SY3
P
a
g
e
8
1.4.2.
4 dip - red
By using the Dip-switches, the factory Head-unit or vehicle can be chosen
which the interface will be connected to.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
Dip 1
Dip 2
Dip 3
Dip 4
Ford
ON
OFF
Sync 3 light (R5) ON
Sync 3 full version OFF
OFF
z.B. Ford Focus 2019
ON
ON
Sync 3 light (R5) ON
Sync 3 full version OFF
OFF
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
2.
Installation
To install the interface, first switch off the ignition and disconnect the vehicle’s battery.
Please read the owner`s manual of the car, regarding the battery`s disconnection! If
required, enable the car`s Sleep-mode (hibernation mode)
In case the sleep-mode does not succeed, the disconnection of the battery can be done
with a resistor lead.
If the necessary stabilized power supply for the interface is not taken directly from the
battery, the chosen connection has to be checked for being constantly stabile.
The interface needs a permanent 12V source!
2.1.
Place of installation
The place of installation differs for the respective Sync3 versions:
Sync3 full version as ALL-IN-ONE Head-Unit
Installation location is behind the head unit - with the ALL-IN-ONE head unit, the
APIM module is attached as a sandwich to the back of the monitor.
Sync3 full version with tablet monitor and separate APIM module
Installation location is behind the monitor and on the APIM module - the APIM
module is located behind the centre console or behind the glove box.
Note:
The radio module is a separate DIN-sized module and is NOT required for installation!
