NAVITEL PWR10 AL SILVER
| 5
EN
Before you start using
1.
Charge the power bank fully before use.
2.
Check the battery level. To do this, press the Check button on the device body. The display will show a number that indicates the
battery charge level 0-100%
3.
Connect the supplied charging cable to a power source and connect to the Type-C input port on the device.
4.
The digital battery indicator flashes while charging and stops flashing when the battery is fully charged.
Charging electronic devices
•
Connect the power cable to the device you want to charge.
•
Connect the other end of the cable to the Type-C or Type-A output connector of the power bank.
•
While charging, the digital indicator lights up.
•
Disconnect the cable after charging.
Precautions
•
Read the manual carefully before using the device.
•
Charge the power bank fully before use. The full performance of the device is only achieved after two or three complete charge and
discharge cycles.
•
Do not disassemble or repair device by yourself. In case of device failure, contact the service center.
•
Do not expose the device to moisture.
•
Do not use the device more than its output rating. Overload outputs above rating may result in a risk of fire or injury.
•
Do not use the device if damaged or modified
•
Do not expose the device to fire or high temperature. Exposure to fire or temperatures above 100 ºC may result in an explosion.
