NAVITAS TSE Series, Руководство по установке

Страница: 4 / 14

TSE & PSE Installation Manual
#1- TRACTION CONTROLLER with Standard Motor Configuration (TSE500/600/1000):
The standard installation configuration is depicted in “Diagram #1” in the middle of this manual. Before
connecting the harnesses to the controller(s) it is recommended to determine which of the optional inputs and
outputs will not be used, and remove them from the harnesses. The
following connections must be made for
all installations:
White/yellow forward switch input
White/grey reverse switch input
White/red SRO/seat switch
White/black brake switch input (or tied to B+)
White/green accelerator sweep input
White/blue accelerator negative input
Orange forward coil negative output
Grey reverse coil negative output
Red battery positive to Controller
The following connections are optional:
White/brown speed limit #1 / Belly button switch input
White/orange speed limit #2
White/purple speed limit #3 / plug detect for TTR50
Blue power steering timed negative output
Brown pump contactor coil negative output **
Yellow field weakening / “D” contactor negative output
** When using a PC pump controller with the SE, the Brown output can be used as a “Line Contactor” driver. If
you would like to do this you must contact Navitas for additional details.
Once you have determined which of the optional wires will not be used, they can be removed from the harness,
and the harnesses can be connected to the controller.
As shown in “Diagram #1”, run a 16 gauge or larger wire from Battery Positive, through a 20 amp fuse to the
key switch. Then run a similar wire from the switched side of the key to the Red wire on the controller. Run a
separate wire from the switched side of the key to feed all of the coils, either directly or through their
appropriate switches, again as per “Diagram #1”.
Then connect each of the control wires from the Navitas harness to their appropriate input or output. This
concludes the control wiring installation.
CABLE CONNECTIONS:
“A1” from motor Bar “A” on Navitas Controller
“A2” from motor Normally Closed side of cont “AF” bar on Navitas
“S1” + “S2” from motor Wipers on contactor assembly
“F” bar on Navitas Normally Open side of contactors
“B+” and “B-“ on Navitas Battery Positive and Negative
Navitas Technologies Ltd. Last Updated: 6/13/2006 Page 2