13
Slide Tray
Changing the Slide Tray
Always lift the slide tray off when it is in the zero position.
The zero positioning lights up when the slide tray trans-
port ring is in the zero position.
Moving the Tray Into the Zero Position
Using the slide change buttons on your projector or
remote control unit
Keep the slide change button pushed down (forward or
backward) until the tray automatically stops at the zero
position.
Using the Kodak Ektapro IR Remote System RA/LP
Press the “0” on the control page and confirm with the
enter key.
Using the power switch
Turn the projector off by the power switch. When the
projector is turned on again, it will complete a system
check and bring the slide tray back to the zero position.
Removing the Slide Tray
In an emergency (such as a transport failure), the tray
can be removed from the projector in any position:
1. First, switch off your projector!
2. Push aside the slide tray lock and hold it while lifting
off the tray.
3. Turn the slide tray over and rotate the base plate until
it clicks into the zero position. Otherwise, the slide
tray cannot be replaced on the projector in the zero
position.
4. Turn the projector on again. The slide remaining in
the slide gate will be ejected by the slide lift and can
be replaced in the slide tray.
