Navistar WorkStar Series, Руководство оператора

Страница: 106 / 258

Operation
Starting Procedures
WARNING
Never start the engine unless you’re sure the
transmission selector is in neutral and the brake
is applied, otherwise accidental movement of the
vehicle can occur, which could result in property
damage, personal injury, or death.
CAUTION
DO NOT crank the engine for more than 30
seconds at a time; wait two minutes after each
try to allow the starter to cool. Failure to follow
these instructions could cause starter damage.
NOTE: Before starting the engine:
• Read and understand the Controls/Features section of this
manual.
• Perform the left and right engine compartment inspections
outlined in the Inspection Guide section of this manual.
• If your vehicle has an optional battery disconnect switch, be
sure that it is in the on position. This switch is cab mounted,
or mounted on the battery box.
NOTE: Automated manual transmissions must be in (N) Neutral
and vehicles with a clutch pedal require the clutch pedal to be
depressed before the starter will engage.
Engine Starting
The ignition switch has four key
positions as follows:
1. ACC (Accessory)
2. OFF
3. ON
4. START
1. Apply the parking brake and place the transmission in
the (N) Neutral position. If equipped with a clutch pedal,
the clutch pedal must be depressed.
2. Turn OFF the headlights and all accessories.
3. Turn the key clockwise to the ON position. If the WAIT
TO START indicator comes on (the glow plugs or the air
intake warmer are warming up), wait until the indicator
goes out and then proceed.
4. Turn the key to the START position.
5. When the engine starts, release the key.
6. The key will return to the ON position and the engine will
continue to run.
7. To stop the engine, rotate the key counterclockwise to
the OFF position.
94
3879634R1