W410 DISPLAY UNIT
MANUAL
Models: W410/D, W410XB/D, W410XW/D, W410EX/D
PREFACE
Thank you for purchasing the Navis anemometer. This manual provides information for the best performance and safe application of
the anemometer display unit. This manual does not cover the anemometer sensors for which the manuals will come separately.
Read this manual carefully before starting the installation. Keep this manual after installation for future reference.
INTRODUCTION
W410 models are long-range receiver/display units which receive data from NAVIS wind sensors, display various wind data, and use
internal and external alarms for warnings about excess wind speed. Smartphone compatibility (W410XB/D model) allows real-time wind
data monitoring on smartphones or tablets. Wi-Fi compatibility (W410XW/D model) allows real-time wind data monitoring on
“Navis
Live
Data” web interface. The optional 4-20 mA output allows connection to external devices.
1. Display
2. Red and Yellow alarm lights
3. Keys
4. Relays signal lights
5. Buzzer
6. SMA antenna connector
Figure 1. (W410 display unit
– front panel)
The W410 display is compatible with NAVIS sensors: WS 010-1 (wind speed sensor, standard range), WS 011-1 (wind speed sensor,
extended range), WSD 010-1 (wind speed/direction sensor, standard range), WSD 011-1 (wind speed/direction sensor, extended range).
MOUNTING
Select the position where the signal reception is strong enough under all conditions. Use remote antenna if necessary.
Display unit can be mounted onto the ferrous surface with four mounting magnets (optional accessories) or with mounting screws (not
enclosed) to any flat surface.
Mounting the display unit with screws:
Unscrew all 4 plastic screws and remove the front panel. Note that the screws can be pulled out only at the correct angle. Place the
rear panel of the display unit to the final mounting position and mark the position for the bores. Remove the casing and drill holes for
the mounting screws. Place the rear panel of the display unit in position and tighten the mounting screws. Attach the front panel of the
display unit with 4 plastic screws.
ANTENNA CONNECTION
Connect the enclosed antenna to the SMA connector on the display unit only when the power supply is switched OFF.
WIRING
Please note! Switch off the power before connecting the power supply to the display unit.
Unscrew all 4 plastic screws and remove the front panel. Connect the 12-24 V DC power supply. For using external alarm devices,
connect them to the relay connection terminals. For using 4-20mA outputs, connect the connection terminals to external devices.
Place the front panel into position and tighten the screws. Do not use excessive force to plastic screws.
Switch ON the power supply and check the operation.
Figure 2. (rear panel)
Figure 3. (rear panel wiring connection)
